Cold Plunge Pool at Home: Which Models Go Deep Enough
September 15, 2026

Cold Plunge Pool at Home: Turning Your Backyard Into a Recovery Space

Cold water immersion has moved from an elite sports recovery protocol to something that plenty of Australians now truly desire. A few steps from your back door, rather than driving across town at six in the morning. The primary obstacle is rarely your total budget or available space; instead, the most critical factor is having adequate depth.

A proper cold plunge pool must allow complete underwater submersion, and this strict specification rules out most marketed plunge pools.

Here is what the temperature range actually is, why depth is the spec that decides everything, which of our models are built for it, and how a cold plunge behaves across an Australian year.

What Counts as a Cold Plunge, in Actual Numbers

"Cold" is not a feeling, it is a range. Guidance drawn from the Australian Institute of Sport puts cold water immersion at 10 to 15 degrees Celsius, for roughly 10 to 15 minutes — see this overview of cold water immersion for coaches. Water colder than that is not better; it mostly gets uncomfortable and harder to stay in long enough to matter. It is worth being straight about the evidence, too. A systematic review in Sports Medicine found mixed results across studies on how much cold water immersion improves athletic performance measures. What people consistently report is feeling recovered and alert afterwards. Build the setup because you want the habit, not because a specific number has been promised to you. The practical takeaway for a backyard build is simple: if the water never gets into that band, you have not built a cold plunge pool. You have built a small swimming pool.

Why Depth Is the Spec That Decides It

The point of immersion is getting your torso under, ideally upright and submerged to the shoulders. That is where the hydrostatic pressure of the water is doing something rather than just cooling your legs. A pool built around a comfortable lounging depth is pleasant to sit in and useless for this. The gap is bigger than it sounds. Our Nova is 3.35m in diameter and 1.51m high — an excellent pool, and the same width as our Astrid. The Astrid is 2.01m. That 500mm is the difference between chest-deep and shoulder-deep for most adults, in pools that look nearly identical from above.

The Two Models Built for It

ModelDimensionsWater volumeWhy it suits cold immersion
Astrid3.35m diameter x 2.01m highapprox. 12,400LOur deepest standard model, with built-in seating and a standing ledge so you can sit or stand fully submerged
Estella3.4m diameter x 2.01m high as standard, available to approximately 2.725mapprox. 13,800L at 2.01mOur largest round pool, and the only model that can be manufactured deeper than standard
  The Astrid is our deepest standard pool and includes built-in seating and a standing ledge, which gives you more than one way to position yourself in the water. The Estella is our largest round model Both are round, which suits a dedicated wellness corner rather than a lap-style layout. A lot of owners pair one with an outdoor shower or a sauna and run proper contrast sessions at home. If neither suits your yard, the full range is worth a look — though be aware that the shallower models genuinely are not built for immersion, and we would rather say so now than after delivery.

The Same Pool Can Run Warm in Winter

This is where a plunge pool beats a dedicated ice bath outright. Add heating and the pool that is a cold plunge in summer becomes a warm soak in winter. One vessel, both ends of the range. One specification to get right before you order: our standard Aqualux membrane interior is rated to a maximum water temperature of 32 degrees. If you are planning sustained heating, hydrotherapy or regular spa jet use, a tiled interior — glass or ceramic — is the finish built to handle it. Compare both on our finishes page. Choosing the finish around your intended use costs nothing at order stage and is expensive to revisit later.

Planning a Cold Plunge Setup

DecisionWhat to weigh up
Placement
  • Put it within a few steps of a shower, sauna or changing space. A plunge you have to walk through the house for is a plunge you will skip in July.
Interior finish
  • Match the finish to how warm you plan to run it, not just how it looks. This is the decision that is expensive to reverse.
Water care
  • Year-round immersion means consistent turnover. Raise your intended use when your equipment package is specified so the system is sized for it.
Site access
  • Both models are large, heavy shells that arrive by truck and are craned into position. Access gets assessed early, before a delivery date is set.
Compliance
  • A cold plunge pool is a pool. It needs a compliant safety barrier, and permit requirements vary by state and council.
  On the last point: a cold plunge pool is subject to the same barrier rules as any other pool. Any pool capable of holding 300mm or more of water needs a compliant safety barrier, and SPASA's overview of Australian pool fencing rules sets out how the heights, gaps and non-climbable zones are measured. Permit and registration requirements sit on top of that and vary by state and local council, so confirm yours before you order. For how the pool actually arrives and gets connected, our pool installation process walks through each stage.

Frequently Asked Questions

Which plunge pool is best for cold immersion?

  • The Astrid and the Estella. The Astrid is our deepest standard model at 2.01m, with built-in seating and a standing ledge. The Estella is standard at 2.01m , making it the deepest pool we can build.

How cold does the water need to be?

  • Cold water immersion is generally defined as 10 to 15 degrees Celsius, for around 10 to 15 minutes. Colder is not better — it simply becomes harder to stay in for a useful length of time.

Do I need a chiller?

  • Only if you want reliable cold water through the warmer months. In winter, a deep unheated pool can sit in or near the immersion range on its own across much of southern Australia. In summer it will not, regardless of depth.

Can I use the same pool as a warm soak in winter?

  • Yes. Add heating and it works at both ends. Match your interior finish to how warm you plan to run it — the standard Aqualux membrane is rated to 32 degrees, while a tiled interior handles sustained higher temperatures and spa jets.

Is a cold plunge pool still subject to pool safety rules?

  • Yes. How you use it makes no difference. It is a pool, it needs a compliant safety barrier, and permit requirements vary by state and local council.

Get Your Free Quote

Thinking about a cold plunge setup for your place? Request a free, no-obligation quote and we will match the model, depth and finish to how you actually intend to use it — including whether a chiller is worth it for your climate. You can also call our Pakenham team on 03 9727 8300, weekdays 8am to 4pm. General guidance only. Cold water immersion is not suitable for everyone — anyone with a heart condition, circulatory condition or who is pregnant should speak to their doctor before starting. Pool barrier and permit requirements are set by state and territory legislation and enforced by your local council; confirm your obligations before construction.

Discover other blogs

Get in touch

Let’s Talk Pools.

Need help planning your plunge pool?

GET A QUOTE